Valve Body Replace

REMOVAL
1. Clean area around pan, then drain transmission fluid.
2. Remove oil pan and gasket, then the oil strainer.
3. On all models, remove oil tubes using a suitable screwdriver, then the manual detent spring.
4. Remove valve body attaching bolts, then disconnect throttle cable.
5. Remove valve body, then the governor apply gasket.

INSTALLATION
1. Install governor apply gasket.
2. Connect manual valve connecting rod.
3. Hold valve body in place, then manually retain cam in downward position and slip cable end into slot.
4. Position valve body in installation position, then Insert and finger tighten attaching bolts. Torque bolts to 7 ft lbs. Attaching bolt lengths (mm) are indicated in Image.
5. Connect solenoid connector.
6. Install detent spring, then insert and finger tighten attaching bolt Torque attaching bolt to 7 ft lbs.
7. Ensure manual lever is in contact with center of roller at tip of detent spring, then install oil tubes.
8. Install and tighten tube clamp attaching bolt, then the oil strainer.
9. Insert magnet into pan, then install oil pan with new gasket
10. Insert oil pan attaching bolts, then torque to 43 inch lbs.
11. Install drain plug with new gasket, then torque to 13 ft lbs.
12. Fill transaxle to specifications, then ensure proper fluid level.