Disassembly and Assembly

1. If necessary, remove governor drive gear using a press and split plate tool no. J-22912, then the bearing cage from drive pinion.
2. Remove O-ring from bearing cage.
3. Replace counter driven gear bearing using split plate tool No. J-22912-01 and adapter tool No. J-23454.
4. Drive in new bearing using tool Nos. J-35661 and J-8092.
5. Remove drive pinion shaft bearing and outer race using a suitable press and split plate tool No. J-22912-01.
6. Install new bearing using tool No. J35664.
7. Remove outer race from bearing cage using tool No. J-26941,then install new outer race into bearing cage using tool Nos. J-29182 and J-8092.
8. Remove oil seals from cage, then press in new oil seal with lip facing downward using tool No. J-35666-1. Ensure oil seal is pressed in to a depth of .39 inch, see image.
9. Face lip of second oil seal upward, then press inward using tool No. J35666-2, until end of seal is flush with surface of cage. Apply a suitable lubricant to lip of seal.