Front Parking Assist Alarm Sensor Replacement

Front Parking Assist Alarm Sensor Replacement

Removal Procedure





1. Remove front bumper fascia. Refer to Front Bumper Fascia Replacement Service and Repair.

2. Disconnect electrical from the front object alarm sensor.

3. Lift the locking tabs on the housing and remove the front object alarm sensor.

Installation Procedure

Note:
Do not refinish previously painted sensors. Excess paint build up will cause the sensor to be inoperative.

1. Paint the front object alarm sensor. Refer to Basecoat/Clearcoat Paint Systems .

2. Ensure the paint does not exceed 6 mils. Use a paint thickness gauge suitable for non-ferrous metals. Refer to Paint Gauges .





3. Insert the sensor into the housing.

4. Connect the electrical connector to the front object alarm sensor.

5. Install the front bumper fascia. Refer to Front Bumper Fascia Replacement Service and Repair.