B071F

DTC B071F
cell-id="">

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis Strategy Based Diagnosis for an overview of the diagnostic approach.

* Diagnostic Procedure Instructions Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptor

DTC B071F 39
- Remote PRNDL Indicator Internal Malfunction

Circuit/System Description

The transmission shift lever position indicator is located on the center console and indicates the current transmission shift level position. The transmission shift lever position indicator receives power and ground and is controlled by the body control module (BCM) via serial data.

Conditions for Running the DTC

The ignition is ON.

Conditions for Setting the DTC

The BCM has detected an internal malfunction in the transmission shift lever position indicator

Action Taken When the DTC Sets

No action is taken

Conditions for Clearing the DTC

The DTC will become history if the BCM no longer detects a malfunction

Reference Information

Schematic Reference

Instrument Cluster Schematics Instrument Cluster Schematics

Connector End View Reference

Component Connector End Views Fuel Pump and Level Sensor Assembly

Description and Operation

Instrument Cluster Description and Operation Instrument Cluster

Electrical Information Reference

* Circuit Testing Circuit Testing

* Connector Repairs Connector Repairs

* Testing for Intermittent Conditions and Poor Connections Testing for Intermittent Conditions and Poor Connections

* Wiring Repairs Wiring Repairs

Scan Tool Reference

Control Module References Control Module References for scan tool information

Circuit/System Verification

1. Ignition ON.

2. Verify DTC B071F 39 is not set.

• If the DTC is set
Replace the P2 transmission shift lever position indicator.

• If the DTC is not set

3. All OK.

Repair Instructions

Perform the Diagnostic Repair Verification Verification Tests after completing the repair.