Camshaft Position Actuator Solenoid Valve Solenoid Replacement - Bank 1 (Right Side) Intake

Camshaft Position Actuator Solenoid Valve Solenoid Replacement - Bank 1 (Right Side) Intake

Removal Procedure




1. Turn the ignition OFF.
2. Remove the front compartment sight shields as necessary. Refer to Front Compartment Sight Shields Replacement (Service and Repair).
3. Disconnect the camshaft position (CMP) actuator valve electrical connector.




4. Remove the CMP actuator valve bolt.
5. Remove the CMP actuator valve.
6. Inspect the CMP actuator valve seal for damage. Replace the seal if necessary.

Installation Procedure

1. Inspect the CMP actuator valve seal for damage. Replace the seal if necessary.




2. Install the CMP actuator valve.

Caution: Refer to Fastener Caution (Fastener Caution).

3. Install the CMP actuator valve bolt and tighten to 10 Nm (89 lb in).




4. Connect the CMP actuator valve electrical connector.
5. Install the front compartment sight shields as necessary. Refer to Front Compartment Sight Shields Replacement (Service and Repair).