Center Bearing Overhaul

Disassembly Procedure





1. Remove the propeller shaft. Refer to Propeller Shaft Replacement - Two Piece.
2. Support the insulator (2) on a vice.
3. Using a suitable tool, press the bearing (3) out of the insulator (2).
4. Discard the bearing, it is not reusable and must be replaced.

Assembly Procedure

^ Tools Required
- J 21474-20 Control Arm Bushing Driver





1. Using the J21474-2O, press the bearing (1) into the insulator (2).
2. Install the propeller shaft. Refer to Propeller Shaft Replacement - Two Piece.