Pulley Removal and Installation
Removal Procedure1. Loosen the power steering pump pulley bolts with the serpentine drive belt still attached.
2. Remove the serpentine drive belt. Refer to Drive Belt Replacement in Engine.
3. Remove the power steering pump pulley bolts.
4. Remove the power steering pump pulley from the pump.
Installation Procedure
1. Install the power steering pump pulley to the pump.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the power steering pump pulley bolts loosely.
3. Install the serpentine drive belt. Refer to Drive Belt Replacement in Engine.
- Tighten the power steering pump pulley bolts to 20 Nm (15 ft. lbs.).