Fuel Line Coupler: Service and Repair

REMOVAL PROCEDURE

CAUTION: Refer to Gasoline/Gasoline Vapors Caution in Service Precautions.

Tools Required
J 42374 Fuel Line Quick Connect Separators

1. Grasp both ends of one fuel line connection and twist 1/4 turn in each direction to loosen any dirt in quick-connect fitting.

CAUTION: Refer to Safety Glasses and Compressed Air Caution in Service Precautions.

2. Use compressed air in order to blow out dirt from the quick-connect fitting.
3. Squeeze the plastic release tabs.
4. Pull the connection apart.

INSTALLATION PROCEDURE

CAUTION: Always apply a few drops of clean engine oil to the male pipe ends before connecting fuel pipe fittings in order to reduce the risk of fire and personal injury.

This will ensure proper reconnection and prevent a possible fuel leak.

During normal operation, the O-rings located in the female connector will swell and may prevent proper reconnection if not lubricated.

1. Make sure that the connectors are clean.
2. Apply a few drops of clean engine oil to the male connector ends.
3. Push the connectors together in order to cause the retaining tabs or fingers to snap into place.
4. Once installed, pull on both ends of each connection in order to make sure that the connection is secure.

NOTE: Refer to Nylon Fuel Lines Notice in Service Precautions.

5. After you connect all of the lines, crank the engine for a few seconds, turn OFF the engine if the engine starts. Then check for any fuel leaks.