Harmonic Balancer - Crankshaft Pulley: Service and Repair

Removal Procedure





1. Remove the drive belt. Refer to Drive Belt Replacement
2. Raise and support the vehicle. Refer to Vehicle Lifting.
3. Remove the 4 splash shield bolts.
4. Remove the splash shield.
5. Remove the crankshaft balancer bolts.
6. Remove the crankshaft balancer from the crankshaft sprocket.

Installation Procedure





1. Install the crankshaft balancer to the crankshaft sprocket.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the crankshaft balancer bolts.
Tighten the crankshaft balancer bolts to 20 Nm (15 ft. lbs.).
3. Install the splash shield.
4. Install the 4 splash shield bolts.
Tighten the splash shield bolts until fully seated.
Do not strip the splash shield bolts.
5. Install the drive belt. Refer to Drive Belt Replacement.
6. Lower the vehicle.