Assist Handle and Molding Replacement - Rear Door
Assist Handle and Molding Replacement - Rear DoorREMOVAL PROCEDURE
1. Remove the ashtray.
2. Remove the retaining screw from the door assist handle molding.
3. Remove the door assist handle molding.
4. Remove the door panel.
5. Disconnect the actuating rod from the door latch.
6. Slide the door assist handle forward.
7. Remove the door assist handle.
INSTALLATION PROCEDURE
1. Install the door assist handle to the door.
2. Connect the actuating rod to the door latch.
3. Install the door panel.
4. Install the door assist handle molding.
5. Install the retaining screw.
Tighten
Tighten to 20 N.m (15 lb ft).
6. Install the ashtray.
7. Verify the door operation.