Front Door Striker: Adjustments

TOOLS REQUIRED
J 42418 Mini Wedge Door Striker Aligner




1. Loosen the striker screws enough to allow movement of the striker.
2. Install J 42418 to striker.
3. Move the striker up or down and inward or outward.
4. Close the door while holding the outside handle in the open position until door is flush with the adjacent panel.
5. Open door.

NOTE: Refer to Fastener Notice in Service Precautions.

6. Tighten the striker screws to specifications.

Tighten
Tighten the screws to 20 N.m (15 lb ft).

7. Remove the J42418 from the striker.