Front Position Sensor Replacement - Electronic Suspension

REMOVAL PROCEDURE
1. Raise the vehicle.
2. Remove the wheel from the vehicle.





3. Disconnect the sensor harness connector from the vehicle harness connector.
4. Disconnect the sensor harness clips from the vehicle at two places.





5. Disconnect the sensor link from the ball stud.
6. Remove the two screws and position sensor from the vehicle.

INSTALLATION PROCEDURE





NOTICE: Refer to Fastener Notice in Service Precautions.

1. Install the position sensor on the vehicle with two screws.
- Tighten two screws to 10 Nm (89 inch lbs.).

2. Connect the sensor link to the ball stud.





3. Connect the sensor harness connector to the vehicle harness connector.
4. Connect the sensor harness clips to the vehicle at two places.
5. Install the wheel onto the vehicle.
6. Lower the vehicle.