Body Control Module: Service and Repair

REMOVAL PROCEDURE

CAUTION: Before servicing any electrical component, the ignition key must be in the OFF or LOCK position and all electrical loads must be OFF, unless instructed otherwise in these procedures. If a tool or equipment could easily come in contact with a live exposed electrical terminal, also disconnect the negative battery cable. Failure to follow these precautions may cause personal injury and/or damage to the vehicle or its components.

1. Remove the electronics bay board.
2. Disconnect the electrical connectors to the body control module (1).
3. Disengage the body control module (1) from the retainers.
4. Remove the body control module (1).

INSTALLATION PROCEDURE
1. Align the body control module (1) to the electronics bay board.
2. Install the body control module to the bay board retainers.
3. Connect the electrical connectors to the body control module (1).
4. Install the electronics bay board.