Component Specifications

DISC BRAKE SPECIFICATIONS (REAR)
Brake Caliper Piston Bore Diameter 40 mm (1.574 in.)
Brake Rotor Diameter (Nominal) 286 mm (11.259 in.)
Brake Rotor Discard Thickness 10 mm (0.393 in.)
Brake Rotor Lateral Runout (On-Vehicle) 0.10 mm (0.004 in.)
Brake Rotor Thickness (New) 12 mm (0.472 in.)
Brake Rotor Thickness After Refinish (Minimum) 11 mm (0.433 in.)
Brake Rotor Thickness Variation (Maximum) 0.0013 mm (0.0005 in.)
Discard Thickness 0.15 mm (0.006 in.)

NOTE: Any brake rotor which does not meet this specification should be replaced. All brake rotors have a discard dimension cast into them. This is a wear dimension and not a refinish dimension.