Horn Relay: Service and Repair

The horn relay is located in the convenience center, behind the IP driver knee bolster energy absorber, directly below the steering column.

REMOVAL PROCEDURE
1. Remove the self-locking screws from the IP driver knee bolster energy absorber.
2. Slide the IP driver knee bolster energy absorber downward in order to release the IP driver knee bolster energy absorber from the tabs.
3. Remove the IP driver knee bolster energy absorber.




4. Remove the horn relay (7) from the convenience center.

INSTALLATION PROCEDURE



1. Install the horn relay (7) to the convenience center.




2. Slide the IP driver knee bolster energy absorber upward in order to secure the IP driver knee bolster energy absorber to the tabs, in order to install the IP driver knee bolster energy absorber.

NOTE: Refer to Fastener Notice in Cautions and Notices.

IMPORTANT: Do not strip the IP driver knee bolster energy absorber self-locking screws.

3. Install the self-locking screws to the IP driver knee bolster energy absorber.

Tighten
Tighten the self-locking screws until the screws are fully seated.