Instrument Panel Storage Compartment - Door Cover Replacement

REMOVAL PROCEDURE
1. Remove the instrument panel (IP) compartment.
2. Remove the IP compartment door.
3. Remove the door handle from the IP compartment panel.
4. Remove the inner cover screws from the IP compartment door.
5. Remove the inner cover from the IP compartment door.

INSTALLATION PROCEDURE
1. Install the inner cover to the IP compartment door.

NOTE: Refer to Fastener Notice in Cautions and Notices.

2. Install the screws to the inner cover of the IP compartment door.

Tighten
Tighten the inner cover screws until fully seated but not stripped.

3. Install the door handle to the IP compartment panel.
4. Install the IP compartment door.
5. Install the IP compartment.