Disassemble / Assemble Procedure

Description:

Disassemble Procedure

1. Remove the injector harness.

2. Spread the injector retaining clip(s) (10) to release the injector(s) (12) from the fuel rail assembly.

3. Remove the injector(s) (12) from fuel rail.

4. Remove the upper (11) and lower (13) O-ring(s) from injector(s).

5. Discard the O-rings.

6. Clean the throttle body O-ring surfaces. Refer to Throttle Body Service.

Assemble Procedure

1. Lubricate the new upper (11) and lower (13) injector O-ring(s) with clean engine oil.

2. Install the new upper (11) and lower (13) injector O-ring(s) on the injector(s) (12).

3. Install the injector(s) (12) to fuel rail with new retainer clip(s) (10).

4. Ensure the injector(s) (12) are aligned by orientating the electrical connector perpendicular to the crankshaft.

5. Install the injector harness.