Input Sprag Assembly Installation

^ Tools Required
- J 38450 Third Clutch Sprag Retaining Ring Tool





1. Install the input sun gear assembly (646) into the third clutch housing (634).
2. Slightly rotate the sprag race (647) to engage the race into the third clutch housing (634).
3. Install one J 38450 at each extremity of the retainer ring (648).
4. Compress the sprag retainer ring (648) using a screwdriver opposite J38450 while pushing down on the outer sprag race (647).
5. Engage the sprag retainer ring into the groove in the third clutch housing (634).
6. Remove the tools.