Idle Speed/Throttle Actuator - Electronic: Service and Repair

CAUTION: Place a dry chemical (Class B) fire extinguisher near work area before attempting any On-Vehicle Service.


REMOVAL
1. Disconnect the IAC valve electrical connector.
2. Remove the 2 retaining screws.
3. Remove the IAC valve.

INSTALLATION
You can re-use the original gasket if it is still in good condition.

1. Thoroughly clean any gasket material from both of the sealing surfaces.
2. Install the gasket.
3. Install the IAC valve.

Tighten screws to 3 Nm (27 in. lb.).

4. Connect the IAC valve electrical connector.