Turn Signal Switch Replacement
NOTE: You may need to refer to Steering Column Repair Procedures for any associated or referenced procedures. Service and RepairREMOVAL PROCEDURE
1. Disable Supplemental Inflatable Restraint (SIR) system.
2. Remove screw caps from upper steering column.
3. Remove screws from upper steering column.
4. Remove upper steering column cover.
5. Remove steering wheel tilt lever. Service and Repair
6. Remove rubber protective cover from lock cylinder.
7. Remove screws from lower steering column cover.
8. Remove lower steering column cover.
9. Depress tabs to release turn signal switch from column.
10. Disconnect turn signal switch electrical connector.
INSTALLATION PROCEDURE
1. Connect electrical connector to turn signal switch.
2. Install turn signal switch to steering column making sure locking tabs engage.
3. Install lower steering column cover.
4. Install screws to lower steering column cover.
5. Install rubber protective cover to lock cylinder.
6. Install steering wheel tilt lever. Service and Repair
7. Install upper steering column cover.
8. Install screws to upper steering column.
9. Install screw caps to upper steering column.
10. Enable SIR system.