Setting Memory Seats and Memory Mirrors

The drivers seat and the inside and the outside mirrors are combined into each memory setting. The seat memory module controls these functions.

IMPORTANT: If memory module control has been replace it must be reprogrammed using Tech 2. Refer to Power Seats for reprogramming procedures.

Up to three users can program their individual seat and mirror positions and call them up as required. To store the adjustment positions place the drivers seat, inside rearview mirror and outside rear view mirror to the desired position. Press the memory switch (M) and the relevant position switch (1, 2 or 3) simultaneously.

Once the memory setting are programmed the inner and outer mirrors and the driver's seat it will return automatically to their programmed positions when the appropriate memory position switch (1, 2 or 3) is pressed. The outer mirrored can be electrically adjusted using the power mirror switch but the new position will not be stored in memory unless the memory is reprogrammed.