Carpet Replacement - Front

REMOVAL PROCEDURE
1. Remove the front seat.
2. Remove the floor console.
3. Remove the center vent duct screw.
4. Remove the center vent duct.
5. Remove the instrument panel sound insulator. Remove the self-locking tabs to release sound insulator.
6. Remove the center pillar lower molding. Remove the center pillar lover molding by pulling rearward.
7. Remove the carpet retainer.
8. Remove the hinge pillar trim finish panel.
9. Remove the carpet (duplicate procedure for other side).

INSTALLATION PROCEDURE
1. Install the carpet.
2. Install the hinge pillar trim finish panel.
3. Install the carpet retainer.
4. Install the center pillar lower molding. Install the center pillar lower molding by snapping in place.
5. Install the instrument panel sound insulator. Install the self-locking tabs to release sound insulator.
6. Install the center vent duct.
7. Install the center vent duct screws.

Tighten
Tighten the center vent duct screws until fully seated and not stripped.

8. Install the floor console.
9. Install the front seat.