DTC 53

Diagnostic Chart:

CIRCUIT DESCRIPTION

The SDM performs test to diagnose critical malfunctions within itself when the ignition switch is turned ON. Upon passing these tests the Ignition, the VLR, and the deployment loop voltages are measured to ensure they are within their respective normal voltage ranges. Next, the SDM proceeds with the Initialization tests including the Diagnostics Resistance Measurements. Then, the SDM goes into a Continuous Monitoring mode.

CONDITIONS FOR SETTING THE DTC

There is a mismatch between the serial data configuration programming request and the SDM determined vehicle system configuration. This malfunction is detected asynchronously when the Ignition voltage is above a specified value.

ACTION TAKEN WHEN THE DTC SETS

^ The SDM turns ON the AIR BAG warning lamp.

^ The SDM sets a diagnostic trouble code.

CONDITIONS FOR CLEARING THE DTC

Current and History DTC codes must be cleared using a scan tool Clear DTC Information command. If the circuit fault has been successfully repaired and the conditions which caused the DTC to set are no longer existing, the DTC may be cleared using the scan tool. If the SDM determines that the vehicle system configuration matches serial data configuration programming attempt, a Current DTC 53 will change to a History DTC 53, which may be cleared using the scan tool.


TEST DESCRIPTION

An example test description follows:

2. This step checks the status of the SIR system programming configuration.