Without CVRSS

REMOVE OR DISCONNECT
1. Air compressor assembly with bracket from vehicle.
2. Rotate spring clip (14) 90° out of slot.
3. Air dryer (2) from air compressor (3).
4. Seal (15) from air compressor (3) if seal (15) did not come off with air dryer (2).

INSTALL OR CONNECT
1. New seal (15) on air dryer (2).

Important:
^ Lubricate seal with silicone lubricant.
^ Spring clip must not be in slots of air compressor.

2. Air dryer (2) with seal (15) in air compressor (3).
3. Rotate spring clip (14) 90° to lock air dryer (2) in place.
4. Air compressor assembly with bracket on vehicle.

Important: Before driving vehicle, turn ignition on and wait approximately 45 seconds. This will permit the Electronic Level Control (ELC) system to execute the Air Replenishment Cycle (ARC) ensuring that the air adjustable shock absorbers are filled with, at least, residual pressure.