Transceiver/Bracket Assembly

REMOVE OR DISCONNECT
1. Remove rear compartment trim.
2. Electrical connection and coax cable.
3. Nut from right rear brace at floor stud.
4. Two (2) mounting screws.
S. Screws from transceiver to mounting bracket.
6. J-Nuts from brackets if brackets are being replaced.

INSTALL OR CONNECT
1. Snap four (4) J-Nuts to bracket. (Use procedure if bracket is being replaced or new installation.)
2. Mount bracket to transceiver with four (4) screws.
3. Align transceiver to right inner wheel housing mounting points.
4. Install two (2) screws at upper mounting points.
5. Nut to brace stud.
6. Electrical connection and coax cable.
7. Rear compartment trim.