Right Side

1. Relieve fuel pressure.
2. Disconnect battery ground cable, then remove air cleaner assembly.
3. Disconnect oxygen sensor and coolant temperature sensor electrical connectors.
4. Remove two forward, upper exhaust manifold to cylinder head attaching bolts.
5. Raise and support vehicle.
6. Remove manifold to converter exhaust pipe attaching bolts.
7. Using suitable jack stands, support engine cradle.
8. Remove rear engine cradle bolts, loosen, but do not remove, front cradle bolts.
9. Lower engine cradle slightly, then remove exhaust manifold attaching bolts, remove manifold.
10. Reverse procedure to install.