Rocker Arm Cover - Right

ROCKER ARM COVER - RH









REMOVE OR DISCONNECT
1. Negative battery cable.
2. Air cleaner.
3. Cruise control cable from servo bracket.
4. Cruise servo.
5. Electrical and vacuum connections from MAP sensor.
6. RH Spark plug wires and conduit.
7. All electrical connections positioned over valve cover.
8. Seven rocker arm cover attaching screws.
9. Rocker arm cover.
10. Rocker arm cover seal and discard.
11. Triangular seals and discard.

CLEAN
1. Sealing surfaces of:
^ Intake manifold
^ Cylinder head
^ Rocker arm cover

INSPECT
1. Sealing surfaces of intake manifold and cylinder head for damage. Nicks and deep scratches should be filled with RTV before rocker arm cover installation.

INSTALL OR CONNECT
1. New triangular seals - use RTV as shown in Figure.
2. New molded seal into groove in rocker arm cover.
3. Rocker arm cover.
4. Seven rocker arm cover attaching screws.

TIGHTEN
^ Attaching screws to 10 Nm (8.0 lbs. ft.).

5. All electrical connections positioned over valve cover.
6. R/H Spark plug wires and conduit.
7. Air cleaner.
8. Negative battery cable.
9. MAP sensor connections.
10. Cruise servo.
11. Cruise cable to bracket near servo.