Rocker Arm Cover - Left

ROCKER ARM COVER - LH









REMOVE OR DISCONNECT
1. Negative battery cable.
2. Air cleaner.
3. Accessory drive belt.
4. Power steering pump and bracket.
5. L/H spark plug wires and conduit.
6. PCV valve.
7. Fuel rail cover.
8. Seven rocker arm cover attaching screws.
9. Rocker arm cover.
10. Rocker arm cover seal and discard.
11. Triangular seals and discard.

CLEAN
1. Sealing surfaces of:
^ Intake manifold
^ Cylinder head
^ Rocker arm cover

INSPECT
1. Sealing surfaces of intake manifold and cylinder head for damage. Nicks and deep scratches should be filled with RTV just before rocker arm cover installation.

INSTALL OR CONNECT
1. New triangular seals - use RTV as shown in Figure.
2. New molded seal into groove in rocker arm cover.
3. Rocker arm cover.
4. Seven rocker arm cover attaching screws.

TIGHTEN
^ Attaching screws to 10 Nm (8.0 lbs. ft.).

5. Fuel rail cover.
6. L/H spark plug wires and conduit.
7. Power steering pump and bracket.
8. PCV valve.
9. Accessory drive belt.
10. Air cleaner.
11. Negative battery cable.