Coolant Pump

COOLANT PUMP

Water Pump And Crossover Assemblies:

Fig. 26 Water Pump Assembly & Housing:

SPECIAL TOOL REQUIRED (or equivalent)
^ J-38816-A, Water pump remover/installer.

REMOVE OR DISCONNECT
1. Drain cooling system.
2. Engine torque strut, position out of way.
3. Air cleaner assembly.
4. Water pump belt cover.
5. Water pump drive belt.
6. Bypass hose.
7. Lower radiator hose from thermostat housing.
8. Pump cover (4 bolts).
9. Water pump from housing using J-38816-A. Turn clockwise to remove.
10. Clean water pump and pump cover sealing surfaces.


INSTALL OR CONNECT
1. Water pump turning counter clockwise to install. Tighten water pump to 100 Nm (73 lb ft).
2. Water pump cover (4 bolts) and tighten to 10 Nm (89 lb in).
3. Lower radiator hose to thermostat housing.
4. Bypass hose.
5. Water pump drive belt.
6. Water pump belt cover.
7. Air cleaner assembly.
8. Engine torque strut.
9. Refill cooling system.