Road Sensing Suspension (RSS)

ROAD SENSITIVE SUSPENSION (RSS) DTC DESCRIPTION

NOTE: These are the only RSS Codes supplied by the OE manufacturer, additional codes obtained with an aftermarket scan tool are not valid codes. Contact the scan tool manufacture for additional assistance.

S010 LF Damper Solenoid Valve Short to Voltage
S011 LF Damper Solenoid Valve Short to Ground
S012 LF Damper Solenoid Valve Open Circuit
S013 LF Damper Solenoid Valve Short Across Load
S015 RF Damper Solenoid Valve Short to Voltage
S016 RF Damper Solenoid Valve Short to Ground
S017 RF Damper Solenoid Valve Open Circuit
S018 RF Damper Solenoid Valve Short Across Load
S020 LR Damper Solenoid Valve Short to Voltage
S021 LR Damper Solenoid Valve Short to Ground
S022 LR Damper Solenoid Valve Open Circuit
S023 LR Damper Solenoid Valve Short Across Load
S025 RR Damper Solenoid Valve Short to Voltage
S026 RR Damper Solenoid Valve Short to Ground
S027 RR Damper Solenoid Valve Open Circuit
S028 LR Damper Solenoid Valve Short Across Load
S030 SSS Solenoid Short to Voltage/Open Circuit
S031 SSS Solenoid Short to Ground
S032 SSS Solenoid Short Across Load
S035 ELC Compressor Relay Short to Voltage
S036 ELC Compressor Short to Ground/Open Circuit
S037 ELC Exhaust Valve Short to Voltage
S038 ELC Exhaust Valve Short to Ground/Open Circuit
S043 Speed Signal Fault
S044 Lift/Dive Signal Fault
S050 RSS Control Module Fault
S051 RSS Control Module Calibration Fault
S060 LF Rotary Sensor Position Signal Fault
S061 RF Rotary Sensor Position Signal Fault
S062 LR Rotary Sensor Position Signal Fault
S063 RR Rotary Sensor Position Signal Fault
S064 LF Rotary Sensor Overcurrent (1)
S065 RF Rotary Sensor Overcurrent (1)
S066 LR Rotary Sensor Overcurrent (1)
S067 RR Rotary Sensor Overcurrent (1)
S070 LF Rotary Sensor Accelerometer Signal Fault
S071 RF Rotary Sensor Accelerometer Signal Fault
S072 LR Rotary Sensor Accelerometer Signal Fault
S073 RR Rotary Sensor Accelerometer Signal Fault
S080 Steering Sensor Input Fault

(1) This code will not turn on the "SERVICE RIDE CONTROL" message, but will be retained in memory.