Engine Block Assemble

Engine Block Assemble





Note:
Apply sealant to all plugs prior to installation.

1. Install the drain plug with sealant in the water pump. Refer to Adhesives, Fluids, Lubricants, and Sealers Adhesives, Fluids, Lubricants, and Sealers.

Caution:
Refer to Fastener Caution Fastener Caution.

2. Install the coolant jacket plugs with sealant and tighten to 35 Nm (26 lb ft).

1. Install the rear oil passage plugs (3) with sealant and tighten to 60 Nm (44 lb ft).

2. Install the other oil passage plugs (1, 2) with sealant and tighten to 35 Nm (26 lb ft).





3. Lubricate the crankshaft position (CKP) sensor O-ring with clean engine oil. Refer to Adhesives, Fluids, Lubricants, and Sealers Adhesives, Fluids, Lubricants, and Sealers.

4. Install the CKP sensor (1) and bolt and tighten to 10 Nm (89 lb in).

5. Install the oil pressure switch (2) and tighten to 26 Nm (19 lb ft).





6. Install the knock sensors (1) and bolts and tighten to 25 Nm (18 lb ft).





7. Install the piston oil nozzle assemblies (1) and tighten to 15 Nm (11 lb ft).