Rear Brake Caliper Vibration Dampener Replacement

Rear Brake Caliper Vibration Dampener Replacement

Removal Procedure

1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.




2. Open the cap (2) of the brake caliper vibration damper (1), to gain access to the internal torx.




3. Remove the brake caliper vibration damper (2) from the brake caliper vibration damper stud (1).
Hold against internal torx of damper stud (1).

4. Remove the damper stud (1) from the rear brake.

Installation Procedure





Caution: Refer to Fastener Caution Fastener Caution.

1. Install the damper stud (1) to the rear brake and tighten to 28 Nm (21 lb ft).

2. Attach the brake caliper vibration damper (2) to the stud (1) by turn in 2 threads ONLY.

3. Tighten the brake caliper vibration damper (2) to 9 Nm (80 lb in) with a suitable tool.




4. Close the cap (2) of the brake caliper vibration damper (1).

5. Lower the vehicle.