P00C7

DTC P00C7

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis Strategy Based Diagnosis for an overview of the diagnostic approach.

* Diagnostic Procedure Instructions Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptor

DTC P00C7
- Intake Air Pressure Measurement System - Multiple Sensors Not Plausible

Circuit/System Description

The Intake Air Pressure Measurement System consists of (3) sensors, the barometric pressure (BARO) sensor, the manifold absolute pressure (MAP) sensor, and the Turbo Boost sensor.

Conditions for Running the DTC

* DTCs P0106, P0107, P0236, P0237, P0238, P2227, P2228, P2229, P2230, or P2610 are not set.

* Ignition ON after greater than 10s since last ignition cycle.

* The BARO, MAP, and Turbo Boost signals are between 50-115 kPA (7-17 psi).

* This DTC runs continuously when the above enabling conditions are met.

Conditions for Setting the DTC

The ECM detects greater than 10 kPA (1.5 psi) difference between all (3) of the Intake Air Pressure Measurement System sensors.

Action Taken When the DTC Sets

DTC P00C7 is a Type B DTC.

Conditions for Clearing the DTC

DTC P00C7 is a Type B DTC.

Reference Information

Schematic Reference

Engine Controls Schematics [1][2]Electrical Diagrams

Connector End View Reference

Component Connector End Views Outside Rearview Mirror - Driver

Electrical Information Reference

* Circuit Testing Circuit Testing

* Connector Repairs Connector Repairs

* Testing for Intermittent Conditions and Poor Connections Testing for Intermittent Conditions and Poor Connections

* Wiring Repairs Wiring Repairs

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions Powertrain Diagnostic Trouble Code (DTC) Type Definitions

Scan Tool Reference

Control Module References Control Module References for scan tool information

Circuit/System Verification

1. Ignition ON, observe the DTC information with a scan tool. Verify that DTCs P0106, P0107, P0236, P0237, P0238, P2227, P2228, P2229, or P2230, are not set.

• If a DTC is set
If a DTC is set, refer to Diagnostic Trouble Code (DTC) List - Vehicle Diagnostic Trouble Code (DTC) List - Vehicle for further diagnosis.

• If no DTC is set

2. Ignition ON, verify the following scan tool parameters are within range of the Altitude vs. Barometric Pressure table. Refer to: Altitude Versus Barometric Pressure Specifications table.

* BARO Sensor

* MAP Sensor

* Turbo Boost Sensor

• If a sensor parameter is not within range
Refer to the appropriate diagnostic below for further diagnosis.

• Barometric Pressure (BARO) Sensor. Refer to: DTC P2227-P2230 P2227

• Manifold Absolute Pressure (MAP) Sensor. Refer to: DTC P0106 P0106

• Turbocharger Boost Pressure Sensor. Refer to: DTC P0236, P0237, or P0238 P0236

• If all sensor parameters are within range

3. All OK

Repair Instructions

Perform the Diagnostic Repair Verification Verification Tests after completing the diagnostic procedure.