Front Parking Assist Alarm Sensor Replacement

Front Parking Assist Alarm Sensor Replacement

Removal Procedure




1. Remove front bumper fascia. Refer to Front Bumper Fascia Replacement .

2. Disconnect electrical from the front object sensor.

Note: The front object sensor is a one piece design. Do NOT twist the sensor cap to try and remove the painted cap. Replacement sensor requires painting to match fascia/bumper body color.

3. Lift the locking tabs on the housing and remove the front object sensor.

Installation Procedure





Note: Ensure the silicone decoupling ring is installed on the sensor to avoid sensor failure.

1. Insert the sensor into the housing.

2. Connect the electrical connector to the front object sensor.

3. Install the front bumper fascia. Refer to Front Bumper Fascia Replacement .