Powertrain Management

DTC P2544

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis Strategy Based Diagnosis for a overview of the diagnostic approach.

* Diagnostic Procedure Instructions Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptors

DTC P2544
- Transmission Torque Request Signal Message Counter Incorrect

Circuit/System Description

To improve shift feel, the transmission control module (TCM) is constantly sending the engine control module (ECM) serial data messages with information regarding it's request for modifying engine speed or torque. The serial data messages are sent through two circuits which are part of a communication network called the controller area network (CAN). The ECM sets DTC P2544 when it detects a discrepancy in the structure of the message causing the integrity of the message to be questioned.

Conditions for Running the DTC

* The engine run time is greater than 0.5 s.

* No other CAN errors are present.

Conditions for Setting the DTC

The ECM detects that the engine speed and torque modification messages from the TCM are either corrupted or intermittently missing for greater than 4 s.

Action Taken When the DTC Sets

* DTC P2544 is a Type B DTC.

* The TCM commands maximum line pressure during shifts, which results in harsh shifts.

* The TCM freezes adaptive functions.

Conditions for Clearing the DTC

DTC P2544 is a Type B DTC.

Diagnostic Aids

An intermittent fault in the CAN circuits will cause the ECM to set DTC P2544.

Reference Information

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions Powertrain Diagnostic Trouble Code (DTC) Type Definitions

Circuit/System Verification

Note:

* DTC 2544 is an informational DTC.

* Diagnose all other engine control module DTCs prior to DTC 2544.

1. Verify that no other DTCs are set except for DTC 2544.

• If any other DTCs are set
Refer to Diagnostic Trouble Code (DTC) List - Vehicle Diagnostic Trouble Code (DTC) List - Vehicle

• If only DTC P2544 is set

2. Replace the K17 Electronic Brake Control Module.

3. Verify the DTC does not set while operating the vehicle within the Conditions for Running the DTC.

• If DTC sets
Replace the K20 Engine Control Module.

• If DTC does not set

4. All OK.

Repair Instructions

Perform the Diagnostic Repair Verification Verification Tests after completing the repair.

Control Module References Control Module References for ECM or control solenoid valve assembly replacement, programming, and setup.