P00C7

DTC P00C7

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis Strategy Based Diagnosis for an overview of the diagnostic approach.

* Diagnostic Procedure Instructions Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptor

DTC P00C7
- Intake Air Pressure Measurement System - Multiple Sensors Not Plausible

Circuit/System Description

The Intake Air Pressure Measurement System consists of (3) sensors, the barometric pressure (BARO) sensor, the manifold absolute pressure (MAP) sensor, and the Turbo Boost sensor.

Conditions for Running the DTC

* DTCs P0106, P0107, P0236, P0237, P0238, P2227, P2228, P2229, P2230, or P2610 are not set.

* Ignition ON after greater than 10s since last ignition cycle.

* The BARO, MAP, and Turbo Boost signals are between 50-115 kPA (7-17 psi).

* This DTC runs continuously when the above enabling conditions are met.

Conditions for Setting the DTC

The ECM detects greater than 10 kPA (1.5 psi) difference between all (3) of the Intake Air Pressure Measurement System sensors.

Action Taken When the DTC Sets

DTC P00C7 is a Type B DTC.

Conditions for Clearing the DTC

DTC P00C7 is a Type B DTC.

Reference Information

Schematic Reference

Engine Controls Schematics (LHU) [1][2]Electrical Diagrams

Connector End View Reference

Component Connector End Views Sunshade - Left

Electrical Information Reference

* Circuit Testing Circuit Testing

* Connector Repairs Connector Repairs

* Testing for Intermittent Conditions and Poor Connections Testing for Intermittent Conditions and Poor Connections

* Wiring Repairs Wiring Repairs

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions Powertrain Diagnostic Trouble Code (DTC) Type Definitions

Scan Tool Reference

Control Module References Control Module References for scan tool information

Circuit/System Verification

1. Ignition ON, observe the DTC information with a scan tool. Verify that DTCs P0106, P0107, P0236, P0237, P0238, P2227, P2228, P2229, or P2230, are not set.

• If a DTC is set, refer to Diagnostic Trouble Code (DTC) List - Vehicle Diagnostic Trouble Code (DTC) List - Vehicle for further diagnosis.

2. Ignition ON, observe the scan tool MAP Sensor, BARO Sensor, and Turbo Boost Sensor parameters. Compare the parameters to the Altitude Versus Barometric Pressure Altitude Versus Barometric Pressure table.

• If one or more sensor parameters are out of range, refer to the appropriate diagnostic for more information.

* DTC P0106: Manifold Absolute Pressure (MAP) Sensor Performance, refer to DTC P0106 P0106 for further diagnosis.

* DTC P0236: Turbocharger Boost System Performance, refer to DTC P0236, P0237, or P0238 P0236 for further diagnosis.

* DTC P2227: Barometric Pressure (BARO) Sensor Performance, refer to DTC P2227-P2230 P2227 for further diagnosis.

Repair Instructions

Perform the Diagnostic Repair Verification Verification Tests after completing the diagnostic procedure.