Antilock Brake System

DTC C0569

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis Strategy Based Diagnosis for an overview of the diagnostic approach.

* Diagnostic Procedure Instructions Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptor

DTC C0569 00
- System Configuration Malfunction

Circuit/System Description

The Electronic Brake Control Module receives serial data messages from other modules. The Electronic Brake Control Module must be configured with the Vehicle Identification Number (VIN), configuration data and vehicle options. If not properly configured after installation, the Electronic Brake Control Module may set a DTC.

The internal fault detection is handled inside the control module. No external circuits are involved.

Conditions for Running the DTC

Ignition ON

Conditions for Setting the DTC

The Electronic Brake Control Module is not programmed.

Action Taken When the DTC Sets

* The Traction/stability Control indicator turns ON.

* The Electronic Brake Control Module disables the traction control, the stability control and the Hill Start Assist for the duration of the ignition cycle.

Conditions for Clearing the DTC

* The DTC clears when the diagnostic runs and passes.

* The history DTC will clear after 40 consecutive fault-free ignition cycles have occurred.

Diagnostic Aids

A newly replaced Electronic Brake Control Module can set one or more DTCs on its initial ignition ON cycle.

Reference Information

Schematic Reference

Antilock Brake System Schematics [1][2]Antilock Brakes / Traction Control Systems

Connector End View Reference

Component Connector End Views Fuel Pump and Level Sensor Assembly

Description and Operation

ABS Description and Operation Description and Operation

Electrical Information Reference

* Circuit Testing Circuit Testing

* Connector Repairs Connector Repairs

* Testing for Intermittent Conditions and Poor Connections Testing for Intermittent Conditions and Poor Connections

* Wiring Repairs Wiring Repairs

Scan Tool Reference

Control Module References Control Module References for scan tool information

Circuit/System Verification

1. Ignition ON.

2. Verify that DTC C0569 00 is not set.

• If DTC C0569 00 is set

1. Program the K17 Electronic Brake Control Module.

2. Verify the DTC does not set.

• If the DTC sets, replace the K17 Electronic Brake Control Module.

• If the DTC does not set.

3. All OK.

• If DTC C0569 00 is not set

3. All OK.

Repair Instructions

Perform the Diagnostic Repair Verification Verification Tests after completing the repair.

Control Module References Control Module References for Electronic Brake Control Module replacement, programming and setup