B369D

DTC B369D

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis Strategy Based Diagnosis for an overview of the diagnostic approach.

* Diagnostic Procedure Instructions Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptors

DTC B369D 00
- Sunroof Sunshade Actuator Malfunction

DTC B369D 39
- Sunroof Sunshade Actuator Internal Malfunction

DTC B369D 42
- Sunroof Sunshade Actuator Calibration Not Programmed

DTC B369D 4B
- Sunroof Sunshade Actuator Calibration Not Learned

Circuit/System Description

The sunshade is controlled by its own integrated motor/controller containing the necessary electronics, motor, hall effect position sensors, as well as the interface to the driver control switches. The motor/controller is capable of controlling motion based on control switch activation and serial data message commands from the body control module (BCM).

Conditions for Running the DTC

The ignition is ON.

Conditions for Setting the DTC

B369D 00

The sunshade module has detected and reported via serial data that the sunshade actuator has an malfunction.

B369D 39

The sunshade module has detected and reported via serial data that the sunshade actuator has an internal malfunction.

B369D 42

The sunshade module has detected and reported via serial data that the sunshade actuator calibration is not programmed.

B369D 4B

The sunshade module has detected and reported via the LIN-Bus that the sunshade actuator calibration is not learned.

Action Taken When the DTC Sets

DTC B369D is stored in the BCM memory.

Conditions for Clearing the DTC

The BCM no longer detects a malfunction in the sunshade actuator circuit.

Reference Information

Schematic Reference

Sunroof Schematics [1][2]Electrical Diagrams

Connector End View Reference

Component Connector End Views Fuel Pump and Level Sensor Assembly

Description and Operation

Sunroof Description and Operation (Spoiler System) Description and Operation

Electrical Information Reference

* Circuit Testing Circuit Testing

* Connector Repairs Connector Repairs

* Testing for Intermittent Conditions and Poor Connections Testing for Intermittent Conditions and Poor Connections

* Wiring Repairs Wiring Repairs

Scan Tool Reference

Control Module References Control Module References for scan tool information

Circuit/System Verification

1. Ignition ON.

2. Verify DTC B369D 42 or DTC B369D 4B is not set.

• If DTC B369D 42 or DTC B369D 4B is set

1. Calibrate the K62 Sunroof Sunshade Motor Module. Refer to Sunroof Motor/Actuator Initialization/Teach Process Testing and Inspection.

2. Verify DTC B369D 42 or DTC B369D 4B does not set while operating the sunroof.

• If DTC B369D 42 or DTC B369D 4B sets, replace the K62 Sunroof Sunshade Motor Module.

• If DTC B369D 42 or DTC B369D 4B does not set

3. All OK.

• If DTC B369D 42 or DTC B369D 4B is not set

3. Verify DTC B369D 00 or DTC B369D 39 is not set

• If DTC B369D 00 or DTC B369D 39 is set, replace the K62 Sunroof Sunshade Motor Module.

• If DTC B369D 00 or DTC B369D 39 is not set

4. All OK.

Repair Instructions

Perform the Diagnostic Repair Verification Verification Tests after completing the diagnostic procedure.

* Sunroof Sunshade Motor Replacement Sunroof Sunshade Motor Replacement

* Control Module References Control Module References for sunshade motor/actuator replacement, setup and programming