51 22 300 Removing and Installing/Replacing Weather Strip on Outside of Rear Door

51 22 300 Removing And Installing/Replacing Weather Strip On Outside Of Rear Door







Special tools required:
- 00 9 324
- 00 9 325







IMPORTANT: Weather strip in plastic design cannot be removed without damage.

Observe procedure for using special tool 00 9 324.
The "Instructions on fitting window guide seals" serve as the basis for this repair instruction and must be observed without fail.







IMPORTANT: If reusing the existing window cavity cover strip (1), make sure it is not bent.

Pry out weather strip (1) with special tool 00 9 324 (starting at B-pillar).
In areas that cannot be reached with special tool 00 9 324, carefully pry out weather strip (1) using special tool 00 9 325.

Installation note:
Moisten weather strip (1) before installation with approved lubricant.
Weather strip (1) must lie flush with the door edge at the front and rear.