51 47 440 Removing and Installing/Replacing Rear Carpet on Seat Pan

51 47 440 Removing And Installing Or Replacing Rear Carpet On Seat Pan







Necessary preliminary work:
- Remove both front seats
- Remove rear seat
- Remove both rear door sill cover strips
- Remove both bottom B-pillar trim panels
- Remove complete centre console
- Remove central bass speaker trim on left/right







Disconnect cable (1) from handbrake check switch.
Unclip cable clip (2) from parking brake lever.
Loosen nuts (3) on cable clip only.

Installation note:
Replace self-locking nuts.

Tightening torque 34 41 1AZ.







IMPORTANT:
- Risk of damage.
- Pay attention to cables when cutting.

Cut carpet (1) along line (2).
Feed carpet (1) out to the top from the parking brake lever (3).







Installation note:
Apertures (1) serve as alignment points when fitting carpet (2).

Replacement:
Lay removed carpet over new one and transfer cuts to new carpet.