Rear Bumper Reinforcement: Service and Repair

51 12 050 Removing And Installing/Replacing Support For Rear Bumper Panel







Necessary preliminary work:
- Remove bumper panel







Depending on version:
- Unscrew screws (1).
- Unlock and disconnect plug connection on Smart Opener control unit and bumper aerial

Loosen the latch mechanisms (2) at reinforcement (3).
Remove reinforcement (3).

Installation note:
Catches (2) must not be damaged or missing.







If necessary, feed out cable.
Unscrew nuts (1).
Tightening torque 51 12 1AZ.
Remove support (2).