Infotainment - CID Intermittently Blank, 'NO SIGNAL' Displayed
SI B65 10 12Audio, Navigation, Monitors, Alarms, SRS
April 2013
Technical Service
This Service Information bulletin supersedes SI B65 10 12 dated January 2013.
[NEW] designates changes to this revision
SUBJECT
Headunit-Basic: CID is blank and "NO SIGNAL" is Displayed
MODEL
F30
Produced from SOP to July 2012 without option 609 (Navigation System Professional)
SITUATION
Intermittently the Central Information Display (CID) is blank and "NO SIGNAL" is displayed on the CID.
^ Fault Code B7F8C3 "no response from CID (HW error: loss of CID communication)" is stored in the HU-B
CAUSE
Error in the Headunit-Basic (HU-B), also called Radio Professional or ENTRY head unit.
[NEW] CORRECTION
1. Perform a vehicle test using the latest ISTA (Integrated Service Technical Application) diagnostic software.
Note:
When the ISTA system message displays: Battery voltage only "XX.XX" V. Please connect charger. Please note the displayed battery voltage reading in the repair order comments section. This documentation is not necessary when part of an approved Technical Service repair procedure; the battery charger is required to be attached before performing the Vehicle Test.
2. When fault code B7F8C3 is stored in the HU-B, reprogram the vehicle using ISTA/P 2.49.2 or later. Otherwise, complete all test modules relevant to head unit faults.
New integration level: F020-13-03-503 or higher
Note that ISTA/P will automatically reprogram and code all programmable control modules that do not have the latest software.
For information on programming and coding with ISTA/P, refer to CenterNet / Aftersales Portal / Service / Workshop Technology / Vehicle Programming.
WARRANTY INFORMATION
[NEW] Covered under the terms of the BMW New Vehicle/SAV Limited Warranty.
Labor operation code 00 00 006 is a Main labor operation. If you are using a Main labor code for another repair, use the Plus code labor operation 00 00 556 instead.
Refer to KSD2 for the corresponding flat rate unit (FRU) allowance. Enter the Chassis Number, which consists of the last 7 digits of the Vehicle Identification Number (VIN). Click on the "Search" button, and then enter the applicable flat rate labor operation in the FR code field.
[NEW] If a control module was working properly and/or had no related faults stored prior to vehicle programming and it fails to program correctly or requires initialization, this additional work must be claimed with separate labor operations under the defect code listed above; refer to KSD2.
Other Repairs
[NEW] If performing other ISTA diagnostics and the related test plans results with eligible and covered work, claim this work with the applicable defect code and labor operations listed in KSD2.