32 13 650 Removing and Installing/Replacing EH Converter For Servotronic

32 13 650 Removing and installing/replacing EH converter for Servotronic





Important!
Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.





Necessary preliminary tasks:
^ Remove reinforcement plate
^ Remove anti-roll bar threaded fastener from front axle support and disengage anti-roll bar





Release screws (1) and nuts (2) and tie lines aside.





Disengage coolant hose from electric motor unit.





Disconnect plug connection (1).

Unfasten screws (2).

Remove EH converter.

Installation note:
Clean side return orifice with compressed air.

Align EH converter to opening in hydraulic steering gear, press by hand into hydraulic steering gear up to stop, insert screws (2) and tighten down.

Tightening torque 32 00 2AZ.





After installation:
^ Fill and bleed hydraulic system