32 41 331 Replacing Pressure Line For Hydraulic Steering

32 41 331 Replacing pressure line for power steering (from steering box to junction)





Warning!
Danger of poisoning if oil is ingested/absorbed through the skin!
Risk of injury if oil comes into contact with eyes and skin!

Important!
Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.
Close off line connections with seal plugs.





Recycling:
Catch and dispose of hydraulic fluid in a suitable collecting vessel.





Necessary preliminary work:
^ Draw off and dispose of hydraulic fluid from oil reservoir
^ Release hydraulic steering gear (F01/F02/F03/F07 only rear-wheel drive)
^ Lower front axle support (F04 and all-wheel drive vehicles)





Release screw (1) and remove pressure line (2) from steering box.

Tightening torque 32 41 5AZ.





Remove return hose (1) from holder (2).





Release screw (1).

Tightening torque 32 41 15AZ.

Release nut (2) on holder.

Tightening torque 32 41 7AZ.

Disconnect pressure line (3).

Installation note:
Replace all sealing rings.

Make sure hydraulic line is laid without tension and with sufficient distance to adjoining components.





After installation:
^ Fill and bleed hydraulic system
^ Check line connections for leak tightness

��P84Q: