Fluid Pan: Service and Repair

24 11 015 Removing And Installing/Sealing Or Replacing Transmission Oil Sump (GA8HP70Z)







IMPORTANT:
- Do not let skin come in contact with transmission oil and do not inhale fuel vapors.
- Wear protective gloves.
- Ensure adequate ventilation.







IMPORTANT:
Remove transmission oil sump only after it has cooled down.
After completion of repair work, check transmission oil level.
Use only the approved transmission oil-Failure to comply with this requirement will result in serious damage to the automatic transmission.

Installation note:
The transmission oil sump must be renewed every time it is removed.







Necessary preliminary tasks:
- Remove rear underbody protection.







Remove retaining plates (2).







Remove oil drain plug (1).
Tightening torque 24 11 2AZ.
Drain automatic transmission oil.







Recycling:
Catch and dispose of escaping transmission oil.
Observe country-specific waste disposal regulations.







Unscrew all bolts.
Remove and renew transmission oil sump.
Clean the contact surface of the transmission oil sump on the transmission.

NOTE: The transmission oil sump must be renewed every time it is removed.

Installation note:
Insert new screws until screw heads make contact.
Tighten down screws in sequence 1... 13 to specified torque.
Tightening torque 24 11 4AZ.

IMPORTANT:
Aluminium screws/bolts must be replaced every time they are released.
Jointing torque and angle of rotation must be observed without fail (risk of damage).