32 41 317 Replacing Intake Pipe For Vane Pump (From Connecting Piece to Vane Pump)

32 41 317 Replacing intake pipe for vane pump (from connecting piece to vane pump)







WARNING:
Danger of poisoning if oil is ingested/absorbed through the skin.
Risk of injury if oil comes into contact with eyes and skin.

IMPORTANT:
Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.
Close off line connections with seal plugs.







Recycling:
Catch and dispose of hydraulic fluid in a suitable collecting vessel.







Necessary preliminary work:
- Draw off and dispose of hydraulic fluid from oil reservoir
- Remove left clean air pipe.
- Release the electromechanical power steering box on the front axle support and pull forwards slightly







Unfasten hose clamp (1).
Release screw (2).
Tightening torque 32 41 8AZ.

Installation note:
Replace hose clamp.







Release hose clamp (1) and detach intake pipe from vane pump.

Installation note:
Replace hose clamp.
Make sure hydraulic lines are laid without tension and with sufficient distance to adjoining components.
Align intake pipe by way of marking (2) to marking on the vane pump connection.







Remove intake pipe (1) in direction of arrow from holder (2).
Remove intake pipe in upward direction.







After Installation note:
- Carry out initial Dynamic Drive operation
- Check pipe connections for leak tightness