32 41 316 Replacing Intake Pipe For Vane Pump (From Oil Reservoir to Connecting Piece)

32 41 316 Replacing intake pipe for vane pump (from oil reservoir to connecting piece)







WARNING:
Danger of poisoning if oil is ingested/absorbed through the skin.
Risk of injury if oil comes into contact with eyes and skin.

IMPORTANT:
Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.
Close off line connections with seal plugs.







Recycling:
Catch and dispose of hydraulic fluid in a suitable expansion tank.







Necessary preliminary work:
- Draw off and dispose of hydraulic fluid from oil reservoir
- Remove oil reservoir from body
- Remove raw-air supply on left







Unfasten hose clamp (1).
Disconnect intake pipe (2) from oil reservoir.

Installation note:
Marks on oil reservoir and intake pipe must match up.
Replace hose clamp.







Unfasten hose clamp (1).
Remove intake pipe (2).

Installation note:
Replace hose clamp.
Make sure intake pipe is laid without tension and with sufficient distance to adjoining components.







After Installation note:
- Start up Dynamic Drive
- Check line connections for leak tightness