11 61 068 Removing and Installing/Replacing Right Intake Manifold

11 61 068 Removing and installing/replacing right intake plenum (N63)







Necessary preliminary work:
- Remove right injection pipe.
- Remove throttle valve
- Release screws on intake plenum from above without fail before lowering front axle.
- Secure engine in installation position.
- Lower front axle, releasing screws on engine mount first
- Release A/C compressor and place to one side.







Detach engine ventilation hose (1).
Disconnect connector.
Unscrew nuts (2).
Tightening torque: 11 61 1 AZ.







Remove throttle valve (2).
Release screw (1).
Tightening torque: 11 61 2 AZ.
Feed out intake plenum towards rear.

Installation note:
Replace all profile seals.







Assemble engine and vehicle.
Check air intake system for leaks.