11 61 065 Removing and Installing/Replacing Left Intake Plenum

11 61 065 Removing and installing/replacing left intake plenum (N63)







Necessary preliminary work:
- Remove left injection pipe.
- Remove throttle valve
- Release screws on intake plenum from above without fail before lowering front axle.
- Secure engine in installation position.
- Lower front axle, releasing screws on engine mount first
- Release power steering pump, if installed, and set aside.
- Universal joint with corrugated tubing.







Detach engine ventilation hose (1).
Disconnect connector.
Unscrew nuts (2).
Tightening torque: 11 61 1 AZ.







Release throttle valve (1).
Release holder screw (2) on intake plenum.
Tightening torque: 11 61 2AZ.
Feed out intake plenum towards rear.

Installation note:
Replace all profile seals.







Assemble engine and vehicle and
Check air intake system for leaks.