11 13 010 Removing and Installing/Replacing Upper Oil Sump Section

11 13 010 Removing and installing/replacing upper oil sump section (N63)







Necessary preliminary work:
- Drain engine oil.
- Secure engine in installation position.
- Lower front axle.
- Remove lower oil sump section.
- Remove front axle differential (AWD only).
- Remove front output shaft bearing support (AWD only).
- Unclip wiring harness on oil sump.







Remove oil filter cover with oil filter (1) with special tool 11 9 240.
Tightening torque: 11 42 1AZ.







Release bolt (1).Remove oil pipes (2) from oil filter housing.
Release holders of supply/return lines on oil sump







Unfasten screws (2).
Tightening torque: 11 41 1AZ.







Release screws in area of line (1).
Tightening torque 11 13 2AZ.
Release screws (2) on transmission end 24 00 1AZ.
Remove upper oil sump section (3).

Installation note:
Free sealing surfaces of seal debris and clean.
Replace gasket.
Modify oil pressure switch if replacing oil sump.







Assemble engine.